Right then. this is ideally what you'll need to do a good job. Though you could get away without the scalpel and tape
1)Necromancer print off (obviously) on photo glossy paper or card.
2)Paper glue.
3)Scissors.
4)Double sided tape
5)Scalpel
6)Straight edge, like a ruler or something (not shown)
|
Here the reverse of the print out. I have found that printers don't always line up the two sides perfectly, so it's best to just use this side as a general guide and cut from the other one.
|
Everything cut out, colored side up and scored for folding, coloured side down to protect the ink, being careful that everything lines up correctly.
If you have one, use the scalpel for all the straight lines, you'll get a much nicer result.
Use scissors to cut out the arms.
Score the folds using one blade of the scissors and a ruler.
|
Cut the arm slots before you do anything else! you won't be able to once you but the body together.
|
Glue the two halves of the arms together like this.
|
Insert the arms through the arms slots of the body, being careful not to leave ahem! gluey fingerprints all over them.
|
Should look like this....
|
Flip the model over and fix the arms using double sided tape if you have it, or glue if you don't. Your life for the next 20 minutes will be much, much easier if you have double sided tape.
|
Fold and stick the edges of the hood.
|
Stick the top of the head together like so. Repeat on the other side
|
The top of the model should look like this. Tuck the tags at the very top of the model in to the hood edge opposite them. fix them in with double sided tape or glue if you can. This is the trickiest bit of the whole model.
|
We're looking at the back of his little face here. Put tape or glue all round the edge and stick the back of his face to the tags inside the hood.
|
Looking at the model from directly below, you should now see this....
|
Hard to see in this photo, but the "stick this area" section has double sided tape on it. Make sure you go right to the edges on this one.
|
Fold in the tags either side of the area you just covered in tape or glue and then fold and stick the bottom of the hood onto that area too, to make the shape above.
|
Again, it's difficult see, but put two strips of double sided tape along the edges of the inside of the necomancer's front side.
|
Fold the front side of the model onto the tabs behind it and stick it there. Then attach the 'bas'e edges to one another, before finally attaching the extra piece of base at the rear.
|
Well done. you made it (maybe.) Sit back and enjoy the calming effects of having a master of the undead in the same room as you.
|
